Content Preview
TB251 Rev1 Type of Ethernet Cable to use for CNC11 Systems
Background
Since CNC11 systems communicate to the Centroid hardware via the Ethernet cable erroneuos errors could arise due to noise seen
on the signals of the Ethernet cable To minimize this issue a shielded Cat5e cable must be used One can build their own Ethernet
cable by following the diagram below Centroid recommends purchasing the blue Cat5e shielded F/UTP snagless patch cables from
StarTech StarTech ID # S45PATCH25BL
Document History
Rev1 Created on 2011 09 14
by #000